Textile ball for Christmas

 cut eight squares 5x5 for the central motif and 16 boxes to a beacon.Balls I got a diameter of 7.5 cm, the size of the squares determined empirically. Yes still need 2 squares for the substrate under the central motif.


All the squares to fold in half and zautyuzhit, so then it will be easier to sew, they are neater fit.

Find a ball pole and to each pin substrate, we watch so that corners of looked at each other.

Smoothed blank triangles add up the pins and spouts to the center, make right on both sides, so that once it was possible to align the line.

Corners sew it all together, place the matching mask the beads (but not necessarily), we derive a needle under the base of the triangle

and sew over the edge all the corners. Received such blotches on both sides.

Further as to impale a second layer of fabric. First, central angles, and then between them, a little lower, that was such a star.

Again, both sides at once. Ideally, should get a straight line in the field of addition. In short, the solid geometry. That's not ideal, but close to it

Corners we catch a couple of stitches and hide under the beads, and again the stitches on the edge, so that nothing is stuck and does not get out later in the operation.

The third layer is a matter of technology:)

Measure the circumference and cut a strip of cloth to hide all our ugliness

Come and hide. :) I sewed the strip, so it does not then slid.

Take the gold ribbon, just for the Christmas ball suitable, middle, sew on strips of masking along with the beads, the top cheat eyelets for beauty, and one longer, to be suspended for that. All the same Christmas decorations you have more:)))

Everyone who read to the end, THANK YOU!