Singed Flower and Kneehigh Headband TUTORIAL

Here's how I made my Singed Flower headband from last week. Several of you said you'd made tons of these, and I've only done a handful, so if you have a better way, helpful tips, or want to add something, let me know and I'll add it in.

Supplies:

• organza fabric made of 100% nylon, rayon, or polyester (you don't need much, scraps will do)
  
• lighter
• scissors
• small piece of felt
  
• pins
• low heat glue gun
• brad for flower center
• knee highs, nylons, or tights (feel free to use that pair of nylons that snagged when you opened them!)
  
• about 3" of coordinating ribbon

To Make a Singed Flower:

Cut circles out of fabric. Make each circle about 3/4" bigger than the previous. I like to use at least 4 circles (I know I only pictured 3, it was late and I was watching American Idol :) I free hand my circles. I like the look of not being perfect. So my circles end up being a little oblongish. Here's roughly circle size I used: 1 1/4",

1 1/2", 1 3/4" and 2 1/4" for the biggest. (I like the outer circle to be slightly bigger.)  

 

Use your lighter and singe the edges of all your circles. Be sure to be aware of what is around you so that you don't start a fire :)

I like to curl the edges a little by heating the sides too.

 

Left is before singeing, and the right is after singeing. 

 

After all circles have been singed, stack them on top of each other.

 

For this next step, find something heat resistant like a cookie sheet. Heat a pin with the lighter for a few seconds and poke it through the center of the circles. Hot hot pin will melt right through.

 

But the brad in the center.

 

Use a low heat glue gun and glue a small piece of felt to the back of the flower. Singed flower is done! yay!

To Make a baby headband from a Knee high (or nylons, tights, etc)

If you're using a knee high, cut off the toe and elastic top.

If you're using baby tights, cut the toe off and then cut a 12" section from the leg.

 

Fold in half.

 

Sew ends together. Will be stretchy, so it is easiest to start 1/4" in and then back-stitch.

 

See how straight mine is...or not. lol The stretchy material makes it hard. But don't worry. We'll cover it up :)

 

Next, pin down each side of the seam 1/2 way down.

 

Then sew across. Should look something like this.

 

Next, using your low heat glue gun, glue the ribbon around the seam to finish the ends (and cover my lovely crocked seams :)
*But there is an alternate ending. Scroll down past this next pic to see a different option.*

Then glue flower to the ribbon and you're done!

If you're looking for a practical way to reuse the headband with different flowers and clips, here's another option for you:

 

Hot glue a strip of elastic or ribbon around the seam but only glue one side to the headband, leaving one side with room to slip a clip through.

 

That way you can make different flowers and only have to make one headband. Just be sure to put your flowers on clips.
Source: craftaholicsanonymous.net/